Power board
Removing the power board
1
Follow the procedure in
Before working inside your computer
.
2
Remove:
a
b
NOTE:
To remove both cards if equipped and no need to remove the blank filler
c
d
3
To remove the power board:
a Peel and flip over the coin cell battery [1].
b Disconnect the power daughter board cable from the system board [2].
c Remove the 2 (M2X3) screws securing the power board in place [3].
d Lift the power board from the computer [4].
Installing the power board
1
Place the power board by aligning it to the screw holes.
2
Replace the 2 (M2.0x3.0) screws to secure the power board to the computer.
3
Connect the power board cable to the connector on the system board.
4
Affix the coin cell battery on the computer.
5
Install the:
Removing and installing components
15
