Dell Latitude 5320, Руководство по обслуживанию

Страница: 57 / 116

Steps
1. Place the display assembly on a clean and flat surface.
2. Align and place the palm-rest and keyboard assembly on the display assembly.
3. Using the alignment posts, close the display hinges.
4. Replace the two screws (M2.5x4) that secure the left-display hinge to the system board.
5. Replace the two screws (M2.5x4) that secure the right-display hinge to the system board.
6. Route the IR camera cable underneath the fan.
7. Connect the IR camera cable to its connector on the system board.
8. Route the antenna cables underneath the fan.
9. Connect the eDP cable on to its connector on the system board and adhere the conductive tape.
10. Connect the display cable to its connector on the system board.
11. Replace the single screw (M2x4) to secure the display cable bracket.
Next steps
1. Install the battery .
2. Install the WWAN card (optional).
3. Install the WLAN card .
4. Install the base cover .
5. Follow the procedure in after working inside your computer .
Display bezel
Removing the display bezel
Prerequisites
NOTE: The display bezel removal procedure is applicable only for Latitude 5320 laptop and not for the 2-in-1 configuration.
1. Follow the procedure in before working inside your computer .
2. Remove the base cover .
3. Remove the battery .
Removing and installing components 57