Installing the docking board
1
Insert the docking board into the slot on the tablet.
2
Replace the M2.0 x 2.0 screws to secure the docking board to the tablet.
3
Affix the docking board cable on the tablet,
4
Connect the docking board cable to the connector on the system board.
5
Install the:
a
b
c
NOTE:
uSIM card is installed only on tablets shipping with WWAN module.
6
Follow the procedure in
After working inside your tablet
.
System Board
Removing system board
1
Follow the procedure in
Before working inside your tablet
2
Remove the:
a
NOTE:
Micro-SIM card slot is available only on tablets shipping with WWAN module.
b
c
d
e
f
g
h
i
3
Disconnect the following cables from the system board .
a docking board cable [1]
NOTE:
Lift the latch and disconnect the docking board cable.
b speaker cable [2]
c USH board cable [3]
28
Removing and installing components
Содержание Latitude 5290 2-in-1
