NOTE:
Ensure that the computer and all attached devices are turned off. If your computer and attached devices did not
automatically turn off when you shut down your operating system, press and hold the power button for about 6 seconds
to turn them off.
After working inside your tablet
CAUTION:
Leaving stray or loose screws inside your tablet may severely damage your tablet.
1. Replace all screws and ensure that no stray screws remain inside your tablet.
2. Connect any external devices, peripherals, and cables that you removed before working on your tablet.
3. Replace any media card, SIM card, and any other parts that you removed before working on your tablet.
4. Connect your tablet and all attached devices to their electrical outlets.
5. Turn on your tablet.
micro SD - micro SIM card
uSIM cards can be installed only on tablets shipped with WWAN module.
1. Follow the procedure in
Before working inside your tablet
.
NOTE:
disconnect the power and drain flea power before preforming the steps
2. Lay the tablet on a plane and flat surface, with the kickstand facing upward.
NOTE:
Pull the kickstand to open by 135° to access the micro SD and micro SIM card slot
CAUTION:
Do not pull or slide more than 135° to avoid damage to the hinges.
3. Slide and lift the cover.
NOTE:
Ensure to turn off or disconnect power, to drain flea power before installing the micro SD and/or micro-SIM.
14
Using your tablet
