Steps
1. Align the screw holes on the hard drive assembly with the mounting points on the palmrest.
2. Replace the four M3x3 screws to secure the hard drive in place and connect the hard drive cable to the connector on the
system board.
Next steps
1. Install the
.
2. Install the
.
3. Install the
.
After working inside your computer
.
Touchpad
Removing the touchpad
Prerequisites
before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
38
Disassembly and reassembly
Содержание Latitude 3410
