Removing the display assembly
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at
Prerequisites
1
Remove the
2
Remove the
3
Remove the
.
4
Remove the
.
Procedure
1
Turn the computer over and open the display as far as possible.
CAUTION:
Place the computer on a soft and clean surface to avoid scratching the display.
2
Peel the tape that secures the touch-screen cable to the system board.
3
Open the latch and disconnect the touch-screen board cable from the system board.
4
Peel the tape that secures the display cable to the system board.
5
Open the latch and disconnect the display cable from the system board.
6
Remove the display cable and touch-screen board cable from the routing guides on the palm-rest assembly.
7
Remove the antenna cables from the routing guides on the palm-rest assembly.
8
Remove the four screws (M2.5x5) that secure the display hinges to the I/O board and system board.
9
Lift the display assembly off the palm-rest assembly.
26
Removing the display assembly
45
Содержание Inspiron 7786
