Steps
1. Peel the tape and disconnect the battery cable, if applicable.
2. Remove the four screws (M2x3) that secure the 3-cell battery to the palm-rest and keyboard assembly.
3. Lift the 3-cell battery, along with its cable off the palm-rest and keyboard assembly.
Installing the 3-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
The following procedure applies only to computers shipped with a 3-cell battery.
The following image indicates the location of the 3-cell battery and provides a visual representation of the installation procedure.
Steps
1. Place the 3-cell battery on the palm-rest and keyboard assembly.
2. Align the screw holes on the 3-cell battery with the screw holes on the palm-rest and keyboard assembly.
3. Replace the four screws (M2x3) that secure the 3-cell battery to the palm-rest and keyboard assembly.
4. Connect the battery cable to the system board and adhere the tape that secures the battery cable to the system board.
Next steps
1. Install the
.
After working inside your computer
.
Removing and installing components
17
