About this task
The following image(s) indicate the location of the I/O board and provides a visual representation of the installation procedure.
Steps
1. Place the I/O board on the palm-rest and keyboard assembly.
2. Align the screw holes on the I/O board with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
4. Adhere the tape over the screw on the I/O board.
5. Connect the coin-cell battery to the I/O board.
6. Connect the I/O-board cable to the I/O board and close the latch.
7. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
8. Replace the two screws (M2.5x4) that secure the left-display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the
.
After working inside your computer
.
Power-button board
Removing the power-button board
Prerequisites
Before working inside your computer
.
2. Remove the
.
Removing and installing components
43
