About this task
The following image(s) indicate the location of the touchpad and provides a visual representation of the installation procedure.
Steps
1. Slide the touchpad onto the palm-rest and keyboard assembly.
2. Replace the two screws (M2x1.8) that secure the touchpad to the palm-rest and keyboard assembly.
3. Align the touchpad bracket and place it on the palm-rest and keyboard assembly.
4. Replace the three screws (M1.6x2) that secure the touchpad bracket to the palm-rest and keyboard assembly.
5. Adhere the adhesive tape to the touchpad bracket.
6. Open the latch of the touchpad connector on the touchpad and connect the touchpad cable to the touchpad.
7. Open the latch of the touchpad connector on the system board and connect the touchpad cable to the system board.
Next steps
1. Install the
, whichever is applicable.
2. Install the
.
After working inside your computer
.
Speakers
Removing the speakers
Prerequisites
Before working inside your computer
.
2. Remove the
.
About this task
NOTE:
The wireless-card antennas are attached to the speakers as an assembly and cannot be separated for individual
replacement. Services will replace the speakers and the wireless antennas as an assembly part.
The following image(s) indicate the location of the speakers and provides a visual representation of the removal procedure.
Removing and installing components
43
