Dell Inspiron 16 5620, Руководство по обслуживанию

Страница: 36 / 69

4. Replace the three screws (M2.5x5) that secure the left display hinge to the palm-rest and keyboard assembly.
5. Close the right display hinge and align the screw holes on the right display hinge with the screw holes on the system board.
6. Replace the three screws (M2.5x5) that secure the right display hinge to the palm-rest and keyboard assembly.
7. Replace the display cable to the routing guides on the palm-rest and keyboard assembly.
8. Connect the display cable to the connector on the system board.
9. Close the latch and replace the clear adhesive tape.
Next steps
1. Install the base cover .
2. Follow the procedure in After working inside your computer .
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in Before working inside your computer .
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer .
2. Remove the base cover .
About this task
The following image(s) indicate the location of the I/O board and provides a visual representation of the removal procedure.
Steps
1. Remove the two screws (M2.5x5) that secure the right-display hinge of the display assembly to the system board.
2. Open the right-display hinge at an angle of 90 degrees.
36 Removing and installing components