Steps
1. Align the notch on the memory module with the tab on the memory-module slot on the system board.
2. Slide the memory module firmly into the memory-module slot at an angle.
3. Press down on the memory module to snap it into place on the system board. Ensure that the memory-module retention
clips have locked the memory module into place.
NOTE:
If you do not hear the click, remove the memory module and reinstall it.
Next steps
1. Install the
.
2. Install the
After working inside your computer
.
M.2 solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
About this task
NOTE:
This procedure applies only to systems shipped with a M.2 2230 solid-state drive installed.
NOTE:
The M.2 card that is installed on your system depends on the configuration ordered. Supported card configurations
on the M.2 card slot are:
●
M.2 2230 solid-state drive
●
M.2 2280 solid-state drive
Removing and installing components
25
Содержание Inspiron 15 3521
