Dell Inspiron 14 7425 2-in-1, Руководство по обслуживанию

Страница: 5 / 66

Working inside your computer
Before working inside your computer
Steps
1. Save and close all open files and exit all open applications.
2. Shut down your computer. For Windows operating system, click Start > Power > Shut down .
NOTE: If you are using a different operating system, see the documentation of your operating system for shut-down
instructions.
3. Disconnect your computer and all attached devices from their electrical outlets.
4. Disconnect all attached network devices and peripherals, such as keyboard, mouse, and monitor from your computer.
5. Remove any media card and optical disk from your computer, if applicable.
6. Enter the service mode, if you are able to power on your computer.
Service Mode
Service Mode is used to cut-off power, without disconnecting battery cable from system board prior conducting repairs in
the computer.
CAUTION: If you are unable to turn on the computer to put it into Service Mode or the computer does not
support Service Mode then proceed to disconnect the battery cable. To disconnect the battery cable, follow
the steps in
Removing the battery .
NOTE: Ensure that your computer is shut down and the AC adapter is disconnected.
a. Hold <B> key on the keyboard and press the power button for 3 seconds or until the Dell logo appears on the screen.
b. Press any key to continue.
c. If the AC adapter is not disconnected, a message prompting you to remove the AC adapter appears on the screen.
Remove the AC adapter and then press any key to continue the Service Mode procedure. The Service Mode procedure
automatically skips the following step if the Owner Tag of the computer is not set up in advance by the user.
d. When the ready-to-proceed message appears on the screen, press any key to proceed. The computer emits three short
beeps and shuts down immediately.
e. Once the computer shuts down, it has successfully entered Service Mode.
NOTE: If you are unable to power on your computer or unable to enter service mode skip this process.
Radiation Exposure Statement
This device meets the government's requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission (FCC) of the U.S. Government.
The exposure standard for wireless device employs a unit of measurement known as the Specific Absorption Rate, or SAR. The
SAR limit set by the FCC is 1.6 W
NOTE: Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting
at its highest certified power level in all tested frequency bands.
1
Working inside your computer 5