Installing the PCIe mezzanine card
on page 72
After working inside your system
on page 52
Installing the Network Daughter Card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
NOTE:
You must remove the NDC to replace a faulty NDC card or service other components inside the system.
CAUTION:
To prevent damage to the NDC, you must hold the card only by its edges.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Remove the PCIe mezzanine card.
4. Remove the NDC.
Steps
1. Align the following:
a. The slots on the card edge with the projection tabs on the plastic bracket covering the PCIe mezzanine card slots.
b. Screw holes on the card with the standoffs on the system board.
2. Lower the card into place until the card connector fits into the corresponding connector on the system board.
3. Secure the card with the two screws.
Figure 34. Installing the Network Daughter Card
1. slot on the NDC
2. screw (2)
3. NDC
4. standoff (2)
5. connector
6. tab projections
Installing and removing server module components
85
