Dell Force10 TeraScale C Series, Справочное руководство

Страница: 933 / 1640

Multicast Source Discovery Protocol (MSDP) | 933
ip msdp sa-filter
e
Permit or deny MSDP source active (SA) messages based on multicast source and/or group from the
specified peer.
Syntax ip msdp sa-filter
{
in | out
}
peer-address list
[
access-list name
]
Remove this configuration using the command
no ip msdp sa-filter
{
in | out
}
peer address list
[
access-list name
]
Parameters
Defaults Not configured
Command Modes CONFIGURATION
Command
History
ip msdp sa-limit
e
Configure the upper limit of SA (Source-Active) entries in SA-cache.
Syntax ip msdp sa-limit number
To return to the default, use the no ip msdp sa-limit number command.
Parameters
Defaults
Default 50000
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS counts the SA messages originated by itself and those received from the MSDP peers. When the
total SA messages reach this limit, the subsequent SA messages are dropped (even if they pass RPF
checking and policy checking). If the total number of SA messages is already larger than the limit
when this command is applied, those SA messages that are already in FTOS will continue to be
accepted. To enforce the limit in such situation, use the
clear ip msdp sa-cache command.
in
Enter the keyword
in
to enable incoming SA filtering.
out
Enter the keyword
out
to enable outgoing SA filtering.
peer-address
Enter the peer address of the MSDP peer in a dotted decimal format
(A.B.C.D.)
access-list name
(OPTIONAL) Enter the IP extended access list name that defines from
which peers SAs are to be permitted or denied.
Version 7.7.1.0 Introduced on E-Series
number Enter the maximum number of SA entries in SA-cache.
Range 0 to 40000
Version 7.5.1.0 Introduced