Dell Force10 TeraScale C Series, Справочное руководство

Страница: 776 / 1640

776 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
neighbor weight
c e
Assign a weight to the neighbor connection, which is used to determine the best path.
Syntax neighbor { ipv6-address | peer-group-name } weight weight
To remove a weight value, use the no neighbor { ipv6-address | peer-group-name } weight
weight command.
Parameters
Defaults
0
Command Modes
ROUTER BGP
Command
History
Usage
Information
In the FTOS best path selection process, the path with the highest weight value is preferred.
network
c e
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ipv6-address prefix-length
[
route-map map-name
]
To remove a network, use the
no network ip-address mask
[
route-map map-name
] command.
Parameters
ipv6-address
Enter the IPv6 address in the
x:x:x:x::x
format.
The
::
notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group to disable all routers within the peer
group.
weight
Enter a number as the weight.
Range: 0 to 65535
Default: 0
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
Note:
Reset the neighbor connection ( capture bgp-pdu max-buffer-size * command) to apply
the weight to the connection and recompute the best path.
ipv6-address prefix-length
Enter the IPv6 address in the
x:x:x:x::x
format followed by the prefix
length in the
/x
format.
Range: /0 to /128
The
::
notation specifies successive hexadecimal fields of zeros.