Dell Force10 TeraScale C Series, Справочное руководство

Страница: 693 / 1640

IPv6 Access Control Lists (IPv6 ACLs) | 693
Defaults Disabled
Command Modes INTERFACE
Command
History
Usage
Information
You can assign an IPv6 access group to a physical, LAG, or VLAN interface context.
Example Figure 25-1. Command Example: ipv6 access-group
ipv6 access-list
c e
Configure an access list based on IPv6 addresses or protocols.
Syntax ipv6 access-list access-list-name
To delete an access list, use the
no ipv6 access-list access-list-name
command.
Parameters
Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packet is dropped.
Command Modes CONFIGURATION
Command
History
implicit-permit
(OPTIONAL) Enter the keyword
implicit-permit
to change the default action
of the IPv6 ACL from implicit-deny to implicit-permit (that is, if the traffic does
not match the filters in the IPv6 ACL, the traffic is permitted instead of dropped).
vlan range
(OPTIONAL) Enter the keyword
vlan
followed by the VLAN range in a comma
separated format.
Range: 1 to 4094
Version 8.4.2.1 Introduced on the S-Series
Version 7.8.1.0 Introduced on the C-Series
Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16
characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale
FTOS(conf-if-gi-9/0)# ipv6 access-group AclList1 in implicit-permit vlan 10-20
FTOS(conf-if-gi-9/0)#show config
!
interface GigabitEthernet 9/0
no ip address
ipv6 access-group AclList1 in implicit-permit Vlan 10-20
no shutdown
Force10conf-if-gi-9/0)#
access-list-name
Enter the as the access list name as a string, up to 140 characters.
Version 8.4.2.1 Introduced on the S-Series
Version 8.2.1.0 Introduced on the E-Series ExaScale
Version 7.8.1.0 Introduced on the C-Series
Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16
characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale