Dell Force10 TeraScale C Series, Справочное руководство

Страница: 354 / 1640

354 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Parameters
Defaults Disabled (that is, private AS number are not removed).
Command Modes ROUTER BGP
Usage
Information
Applies to EBGP neighbors only.
You must configure your system to accept 4-Byte formats before entering a 4-Byte AS Number.
If the AS-PATH contains both public and private AS number or contains AS numbers of an EBGP
neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software removes the private AS
numbers only if they follow the confederation numbers in the AS path.
Private AS numbers are 64512 to 65535 (2-Byte).
Command
History
neighbor route-map
c e s
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer
group.
Syntax neighbor { ip-address | peer-group-name } route-map map-name { in | out }
To remove the route map, use the no neighbor { ip-address | peer-group-name } route-map
map-name { in | out } command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of the route
map are permitted.
ip-address
Enter the IP address of the neighbor to remove the private AS numbers.
peer-group-name
Enter the name of the peer group to remove the private AS numbers
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Added 4-Byte support.
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
map-name Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all routes).
in
Enter the keyword
in
to filter inbound routes.
out
Enter the keyword
out
to filter outbound routes.