Dell Force10 TeraScale C Series, Справочное руководство

Страница: 1388 / 1640

1388 | SONET
www.dell.com | support.dell.com
Parameters
Defaults as above
Command Modes INTERFACE
Usage
Information
You enter the flag C2 and J0 values in decimal, but the FTOS displays the values in hexidecimal in the
show controllers sonet
command output.
framing
e
Set the type of framing used on a POS/SDH interface.
Syntax framing
{
sdh
|
sonet
}
To return to the default, enter
no framing
.
Parameters
Defaults sonet
Command Modes INTERFACE
Usage
Information
Framing should be changed only when the interfaces are shutdown.
hardware monitor mac action-on-error port-shutdown
e
Shut down and bring back up the port (flap).
Syntax hardware monitor mac action-on-error port-shutdown
Defaults Not configured
Command Modes CONFIGURATION
Command
History
c2 value
Enter the keyword
c2
followed by value to set the path signal byte.
Range: 0x00 to 0xFF hexadecimal (0-255 decimal)
Default: 0xCF in hexidecimal (207 in decimal)
j0 value
Enter the keyword
j0
to set the section trace byte.
Range: 0x00 to 0xFF hexadecimal (0-255 decimal)
Default: 0xCC (204 in decimal)
sdh
Enter the keyword
sdh
to specify Synchronous Digital Hierarchy (SDH) framing.
Default: Sonet
sonet
Enter the keyword
sonet
to specify SONET framing.
Default: Sonet
Version 7.7.1.0 Introduced command