Dell Force10 TeraScale C Series, Справочное руководство

Страница: 1090 / 1640

1090 | Policy-based Routing (PBR)
www.dell.com | support.dell.com
Command
History
seq
c e s
Configure a filter with an assigned sequence number for the redirect list.
Syntax seq sequence-number {permit | redirect {ip-address | sonet slot/port}} { ip-protocol-number
| protocol-type } { source mask | any | host ip-address } { destination mask | any | host
ip-address } [bit] [ operator ]
To delete a filter, use the no seq sequence-number command.
Parameters
Version 8.4.2.1 Introduced on the C-Series and S-Series
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 7.4.1.0 Added the bit variable for TCP protocols only
Version 6.5.3.0 Introduced on the E-Series ExaScale
sequence-number Enter a number from 1 to 65535.
permit
Enter the keyword
permit
assign the sequence to the permit list.
redirect
Enter the keyword
redirect
to assign the sequence to the redirect list.
ip-address
Enter the IP address of the forwarding router.
sonet slot/port
Enter the keyword
sonet
followed by the slot/port information.
ip-protocol-number Enter a number from 0 to 255 for the protocol identified in the IP protocol
header.
protocol-type Enter one of the following keywords as the protocol type:
•
icmp
for Internet Control Message Protocol
•
ip
for Any Internet Protocol
•
tcp
for Transmission Control Protocol
•
udp
for User Datagram Protocol
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x).
any
Enter the keyword
any
to specify that all traffic is subject to the filter.
host ip-address
Enter the keyword
host
followed by the IP address to specify a host IP
address.
destination
Enter the IP address of the network or host to which the packets are sent.