Dell Force10 TeraScale C Series, Справочное руководство

Страница: 1056 / 1640

1056 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
EXEC Privilege
Command
History
Usage
Information
If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a
specific OSPF process. If you do not enter the Process ID, only the first configured process is listed.
This command is useful in isolating routing problems between OSPF and RTM. For example, if a route
is missing from the RTM/FIB but is visible from the display output of this command, then likely the
problem is with downloading the route to the RTM.
This command has the following limitations:
• The display output is sorted by prefixes; intra-area ECMP routes are not displayed together.
• For Type 2 external routes, type1 cost is not displayed.
Example Figure 38-18. Command Example: show ip ospf process-id routes
show ip ospf statistics
c e s
Display OSPF statistics.
Syntax show ip ospf process-id statistics global |
[
interface name
{
neighbor router-id
}]
Parameters
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and E-Series
FTOS#show ip ospf 100 route
Prefix Cost Nexthop Interface Area Type
1.1.1.1 1 0.0.0.0 Lo 0 0 Intra-Area
3.3.3.3 2 13.0.0.3 Gi 0/47 1 Intra-Area
13.0.0.0 1 0.0.0.0 Gi 0/47 0 Intra-Area
150.150.150.0 2 13.0.0.3 Gi 0/47 - External
172.30.1.0 2 13.0.0.3 Gi 0/47 1 Intra-Area
FTOS#
process-id
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
global
Enter the keyword
global
to display the packet counts received on all running
OSPF interfaces and packet counts received and transmitted by all OSPF
neighbors.