Dell Force10 TeraScale C Series, Справочное руководство

Страница: 100 / 1640

100 | Control and Monitoring
www.dell.com | support.dell.com
reset
c e
Reset a line card, RPM, a standby SFM (EtherScale only), or a failed SFM (TeraScale only).
Syntax reset { linecard number [ hard | power-cycle ] | rpm number [ hard | power-cycle ] | sfm slot
number | standby }
Parameters
Defaults
Disabled.
Command Modes
EXEC Privilege
Command
History
Usage
Information
The command reset without any options is a soft reset, which means FTOS boots the line card from
its runtime image. The hard option reloads the FTOS image on the line card. Use the power-cycle
after upgrading an FPGA.
When a soft reset is issued on a line card ( reset linecard number ), FTOS boots the line card from its
runtime image. Only when you enter reset linecard number hard is the software image reloaded on
the line card.
Related
Commands
rpm <slot> location-led
e
x
Toggle the location LED on/off on the E-Series ExaScale RPM (LC-EH-RPM).
Syntax rpm slot
number
location-led
[
on | off
]
linecard number
Enter the keyword
linecard
and a number for the line card slot number.
(Optional) Add the keyword
hard
or
power-cycle
(
power-cycle
is C-Series
only) to power cycle the line card.
C-Series Range: 0-7
E-Series Range: 0 to 13 on E1200/E1200i, 0 to 6 on E600/E600i, and 0 to 5 on E300
hard
Enter the keyword
hard
to power cycle the line card.
power-cycle
Enter the keyword
power-cycle
after upgrading a C-Series FPGA to cause the
FPGA to be reprogrammed based on the contents of the FPGA PROM.
Note: This option is supported on C-Series only.
rpm number
Enter the keyword
rpm
followed by a number for the RPM slot number.
(Optional) Add the keyword
hard
or
power-cycle
(C-Series only) to power
cycle the RPM.
Range: 0 to 1
sfm standby
Enter the keyword
sfm standby
to reset the standby SFM.
Note: This option is supported on E-Series EtherScale only.
sfm slot number
Enter the keyword
sfm
followed by the failed or powered-off SFM slot number.
Note: Supported on E-Series only
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
reload Reboots the system.
restore fpga-image Copy the backup C-Series FPGA image to the primary FPGA image.