Dell EqualLogic FS7600, Инструкция по установке и настройке

Страница: 16 / 46

Table 6: Back-Panel Components
Number Component
1
Service tag
Displays the appliance service tag information (identical to the service tag information on the
front panel).
2
Power supply (one of two)
Left: PSU1 Right: PSU2
3 Controller release latch
4 Controller handle
5
Controller (one of two): Redundant NAS processing unit
Left: Controller 1 Right: Controller 2
6
Serial COM port (mini USB connector)
Allows you to connect a serial device to the system.
This connector is for service only. Use this connector only if asked to do so by Dell
support.
7 USB ports
8 Video port
9
From left to right: Service Action Button, Power-On Indicator/Power Button, Controller
Health Indicator, System Identification Button, and Cache Active/Off-Load LED. For
information about these indicators and buttons, see the FS7600 NAS appliance
Hardware
Owner's Manual .
10 Remote KVM
Guidelines for Installing Mounting Rails in a Rack
Plan where to install the mounting rails. The appliance uses 2U of rack space.
Dell recommends that you install the rails according to the following guidelines:
• Make sure the rack meets the requirements in Rack Requirements on page 7 . The graphics in this manual
show a square-hole rack, but the installation instructions also apply to round-hole racks.
• Install hardware starting from the bottom of the rack.
Steps for Installing an Appliance in a Rack
You need at least two persons to install the appliance in a rack.
1. Obtain the rail kit. See Shipping Box Contents on page 6 .
2. Position the left and right rails in the orientation in which you will install the rails.
3. Attach the rails to the rack. See Attaching the Rails to the Rack on page 11 .
4. Slide the appliance into the rack.
5. Secure the appliance to the rack. See Securing the Appliance to the Rack on page 12 .
10
Dell EqualLogic FS7600 Installation and Setup Guide 2 Hardware Rack Mounting