Figure 41. Installing the optical drive cage or tape drive
Next steps
1
Follow the procedure listed in
After working inside your system
.
2
If applicable, install the bezel.
Cabled drives
Your system supports up to four 3.5 inch (SAS or SATA) cabled drives. Cabled drives are installed in an internal drive bay.
CAUTION:
Do not turn off or restart your system while the drive is being formatted. Doing so can cause a drive
failure.
Removing the internal hard drive bay
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Disconnect the data and power cable(s) from the hard drive(s).
Steps
1
Loosen the two captive screws securing the internal hard drive bay to the chassis.
2
Lift the internal hard drive bay up and out of the chassis.
92
Dell EMC PowerEdge T440 Installation and Service Manual
Installing and removing system components