Steps
1
Using a Torx #T30 screwdriver, loosen the screws on the heat sink.
NOTE:
Ensure that you loosen one screw before moving on to the next screw.
2
Pushing both retention clips simultaneously, lift the processor and heat sink module (PHM) out of the system.
3
Set the PHM aside with the processor side facing up.
Figure 44. Removing a processor and heat sink module (2U)
Next steps
1
Install the PHM.
Related links
Removing the air shroud
Opening and closing the PCIe card holder latch
Installing a processor and heat sink module
Removing the processor from the processor and heat sink
module
Prerequisites
WARNING:
The heat sink may be hot to touch for some time after the system has been powered down. Allow the heat sink to
cool before removing it.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Remove the processor and heat sink module.
Steps
1
Place the heat sink with the processor side facing up.
2
Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
paste seal.
3
Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
97