Figure 52. Closing the PCIe card holder latch
Next steps
Follow the procedure listed in
After working inside your system
Removing the expansion card from expansion card riser
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
If applicable, remove the air shroud.
4
If applicable, disconnect the cables from the expansion card.
5
When removing a card from riser 2 or 3, ensure that the PCIe card holder latch is closed.
Steps
1
Pull the expansion card latch out of the slot.
2
Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
107
