Installing the processor into a processor and heat sink module
Prerequisites
Follow the safety guidelines listed in
Steps
1
Place the processor in the processor tray.
NOTE:
Ensure that pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor.
2
Flex the outer edges of the bracket around the processor ensuring that the processor is locked into the clips on the bracket.
NOTE:
Ensure that pin 1 indicator on the bracket is aligned with the pin 1 indicator on the processor before placing the
bracket on the processor.
NOTE:
Ensure that the processor and the bracket are placed in the tray before you install the heat sink.
Figure 40. Installing the processor bracket
3
If you are using an existing heat sink, remove the thermal grease from the heat sink by using a clean lint-free cloth.
4
Use the thermal grease syringe included with your processor kit to apply the grease in a quadrilateral design on the top of the
processor.
CAUTION:
Applying too much thermal grease can result in excess grease coming in contact with and contaminating the
processor socket.
NOTE:
The thermal grease syringe is intended for single use only. Dispose the syringe after you use it.
Dell EMC PowerEdge R640 Installation and Service Manual
Installing and removing system components
91