System board
Removing the system board
Prerequisites
CAUTION:
Do not attempt to remove the TPM plug-in module from the system board. Once the TPM plug-in
module is installed, it is cryptographically bound to that specific system board. Any attempt to remove an
installed TPM plug-in module breaks the cryptographic binding, and it cannot be reinstalled or installed on
another system board.
CAUTION:
To avoid damage to the system board, ensure that the system board does not touch the side walls of
the sled chassis, while sliding the system board into the sled.
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in
Before working inside your system
3.
from the chassis.
4.
.
5.
Remove the expansion card risers
6.
.
7.
8.
.
9. If installed,
10.
11. Disconnect all the cables from the system board.
12. Keep the Phillips #1 screwdriver and #4 nut driver ready.
Steps
1. Using a Phillips #1 screw driver, remove the screws that secure the system board to the chassis.
2. Using a 5mm hex nut driver, remove the standoff screws that secure the system board to the chassis.
CAUTION:
Do not lift the system board by holding a memory module slot, any other connector, or
component.
Figure 64. System board screws
3. To disengage the ports from the slots on the chassis, push the system board to the front of the chassis.
4. Hold the system board by the edges and lift it at an angle and remove it from the chassis.
66
Installing and removing system components
Содержание EMC PowerEdge C6525
Страница 11: ...Figure 7 Mechanical overview Figure 8 Memory information Dell EMC PowerEdge C6525 overview 11 ...
Страница 12: ...Figure 9 Jumper settings Figure 10 System tasks 12 Dell EMC PowerEdge C6525 overview ...
Страница 37: ...Figure 28 Removing an expansion card from riser 2 Installing and removing system components 37 ...
Страница 40: ...Figure 32 Removing the expansion card filler bracket 40 Installing and removing system components ...
