Dell EMC Core XC750, Инструкция по установке и обслуживанию

Страница: 142 / 186

Installing the BOSS S2 module
The procedure to install is the BOSS S2 module with 4 x 2.5-inch rear drive module is same.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in Before working inside your system
3. If installed, remove the BOSS module blank
Steps
1. Connect the BOSS S2 power and signal cables to the connectors on the BOSS S2 module.
Figure 155. Connecting the BOSS S2 power and signal cables to the BOSS S2 module
2. Align the BOSS S2 module at an angle with the controller card module slot.
3. Insert the BOSS S2 module and push the module horizontally towards the rear of the system until firmly seated.
4. Using the Phillips #1 screwdriver, secure the BOSS S2 module with the M3 x 0.5 x 4.5 mm screw.
5. Connect the BOSS S2 power and signal cable to the connectors on the system board.
142 Installing and removing system components