Dell Edge 3000 Series, Инструкция по установке и эксплуатации

Страница: 54 / 67

S System PowerOff
Run the following command:
DGPLQ#ORFDOKRVWVXGRSRZHURII
The system shuts down successfully.
Network communication interfaces
The Edge Gateway 3000 series comes with one Ethernet connection, one 802.11b/g/n wireless network connection, and one
Bluetooth network connection.
Ethernet (Port 1, eth0)
Assuming that you have an internet-enabled Ethernet cable plugged into Port1, your screen should be similar to the one below after
running the
LIFRQILJ
command. If the WLAN and Bluetooth are not configured, they are not displayed in the network device list.
DGPLQ#ORFDOKRVWaLIFRQILJ
After running the
LIFRQILJ
command:u
HWK/LQNHQFDS(:DGGUHHHI
LQHWDGGU%FDVW0DVN
LQHWDGGUIHHHIIIHHI6FRSH/LQN
83%52$'&$675811,1*08/7,&$670780HWULF
5;SDFNHWVHUURUVGURSSHGRYHUUXQVIUDPH
7;SDFNHWVHUURUVGURSSHGRYHUUXQVFDUULHU
&ROOLVLRQVW[TXHXHOHQ
5;E\WHV.%7;E\WHV.%
OR/LQNHQFDS/RFDO/RRSEDFN
LQHWDGGU0DVN
LQHWDGRVW
83/223%$&.5811,1*0780HWULF
5;SDFNHWVHUURUVGURSSHGRYHUUXQVIUDPH
7;SDFNHWVHUURUVGURSSHGRYHUUXQVFDUULHU
&ROOLVLRQVW[TXHXHOHQ
5;E\WHV.%7;E\WHV.%
DGPLQ#ORFDOKRVWa
WLAN (wlan0)
Use these identifiers in the following examples:
•
VVLGQDPH! LRWLVYODE
, where
VVLG
is the name of access point.
•
QDPH! WHVWZLIL
, where
QDPH
is the connection name, which is basically a connection identifier.
•
NH\W\SH! ZSDSVN
, where
NH\W\SH
is the WLAN key management security type being used.
•
SDVVFR! KDSS\
, where
SDVVFR
is the WLAN passcode or password for the access point.
Enter the following at the command prompt to view the network interfaces.
QHWZRUNPDQDJHUQPFOLG
Enter the following at the command prompt to find a list of available access points.
QHWZRUNPDQDJHUQPFOLGZLIL
Run the following commands and replace $SSID, $PSK, and $WIFI_INTERFACE of your environment.
• Connect
VXGRQHWZRUNPDQDJHUQPFOLGHYZLILFRQQHFW66,'SDVVZRUG36.LIQDPH
:,),B,17(5)$&(
OR
VXGRQHWZRUNPDQDJHUQPFOLGHYZLILFRQQHFW66,'SDVVZRUG36.
54