When replacing this system board, you must supply the recovery key when you restart your system or program before
you can access the encrypted data on your hard drives.
CAUTION:
Once the TPM plug-in module is installed, it is cryptographically bound to that specific system board. Any
attempt to remove an installed TPM plug-in module breaks the cryptographic binding, the removed TPM cannot be
reinstalled or installed on another system board.
Removing the TPM
Steps
1. Locate the TPM connector on the system board.
NOTE:
To locate the TPM connector on the system board, see the
2. Press to hold the module down and remove the screw using the security Torx 8-bit shipped with the TPM module.
3. Slide the TPM module out from its connector.
4. Push the plastic rivet away from the TPM connector and rotate it 90° counterclockwise to release it from the system board.
5. Pull the plastic rivet out of its slot on the system board.
Installing the TPM
Steps
1. To install the TPM, align the edge connectors on the TPM with the slot on the TPM connector.
2. Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.
3. Press the plastic rivet until the rivet snaps into place.
Figure 110. Installing the TPM
Next steps
1. If removed,
2.
3.
.
4. Install the
.
5. Place the system into the rack. For more information, see the
Rail Installation Guide
6.
7. Install the
.
8. Follow the procedure listed in
After working inside your system
Initializing TPM for BitLocker users
Steps
Initialize the TPM.
For more information, see
https://technet.microsoft.com/en-us/library/cc753140.aspx
.
Installing and removing system components
121
