Figure 95. Installing the M.2 SSD module
Next steps
1.
into the riser.
NOTE:
The procedure to install the BOSS card is similar to removing an expansion card.
2.
3.
.
4. Follow the procedure listed in
After working inside your system
on page 27.
Optional IDSDM module
Removing the IDSDM card
Prerequisites
1. Follow the safety guidelines listed in the
on page 26.
2. Follow the procedure listed in the
Before working inside your system
3.
.
4. If you are replacing the IDSDM card,
.
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the pull tab, lift the IDSDM card out of the system.
NOTE:
There are two dip switches on the IDSDM card for write-protection.
Installing and removing system components
91
