Dell E36S Series, Руководство пользователя

Страница: 77 / 120

1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Locate the USB connector or USB memory key on the system board.
NOTE: To locate the internal USB connector on the system board, see the System board connectors section.
2. If installed, remove the USB memory key from the USB connector.
3. Insert the replacement USB memory key into the USB connector.
Figure 38. Removing the internal USB memory key
a. USB memory key
b. USB port
Figure 39. Installing the internal USB memory key
a. USB memory key
b. USB port
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. While booting, press F2 to enter System Setup and verify that the USB memory key is detected by the system.
Expansion cards
NOTE: An SEL event is logged if an expansion card is unsupported or missing. It does not prevent your system from
turning on and no BIOS POST message or F1/F2 pause is displayed.
Expansion card installation guidelines
Your system supports Generation 3 cards. The following table lists the supported expansion cards:
Installing and removing system components 77