Dell Dimension V333, Руководство по обслуживанию

Страница: 54 / 100

4-10 Dell Dimension V xxx and V xxx c Systems Service Manual
8SSHU,QFK'ULYH
)LJXUH 8SSHU ,QFK 'ULYH 5HPRYDO
To remove an upper 3.5-inch drive, follow these steps:
1. Remove the bezel.
2. Remove the drive cage and drives as an assembly.
3. Remove the plastic insert from the bezel.
4. Remove the
6/32
x
1/4
-inch screw securing the drive bracket to the drive
cage, and then remove the bracket as shown in Figure 4-8.
NOTES: The three screws used to secure the drive to the bracket and to
the left side of the drive cage have 3-mm threads. Be sure to use the cor-
rect 3 x 5-mm screws when you secure the drive to the bracket and the
drive to the cage.
Also note which screw was used to secure the drive bracket to the drive
cage in step 4, and use the same
6/32
x
1/4
-inch screw when reinstalling the
bracket with its attached drive.
When you replace a drive, be sure to set the jumpers on the replacement drive
the same as the jumpers on the drive you removed. For additional information
about jumper settings on EIDE drives, see “EIDE Subsystem” in Chapter 1.
drive bracket
screws for
drive assembly (3)
drive-bracket
mounting screw