Steps
1. To remove the PCIe dummy bracket, insert a flat-head screwdriver in the hole of the bracket, push the bracket to release it,
and then lift the bracket out of the system.
2. Lift the pull tab to open the PCIe door.
3. Insert the optional SMA module into its slot on the system board.
Next steps
1. Install the
.
after working inside your computer
.
Removing the Dell Ultra Speed Drive Gen4 card
Prerequisites
before working inside your computer
.
2. Remove the
.
About this task
The following images indicate the location of the Dell Ultra Speed Drive Gen4 card and provide a visual representation of the
removal procedure.
Steps
1. Using the tab, lift and open the PCIe door.
2. Press down on the release tab and lift the Dell Ultra Speed Drive Gen4 card off the system board.
Installing the Dell Ultra Speed Drive Gen4 card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
45
Содержание D32M
