Dell C9000 series, Справочное руководство

Страница: 836 / 2286

show ip dhcp snooping
Display the contents of the DHCP binding table or display the interfaces configured with IP Source Guard.
C9000 Series
Syntax
show ip dhcp snooping [binding | source-address-validation
[discard—counter | interface
interface ]]
Parameters
binding Display the interfaces configured with IP Source Guard.
source-address-
validation Display the interfaces configured with IP Source Guard.
discard-counter Display the drop count of the packets.
interface interface Enter the keyword
interface
then type one of the following
interface types and slot/port or number information:
• For a 1–Gigabit Ethernet interface, enter the keyword
gigabitethernet
.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet
.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
.
• For a Port Channel interface, enter the keyword
port-
channel
then a number. Range is from 1 to 4096.
• For a port extender (PE) Gigabit Ethernet interface, enter
the keyword
peGigabitEthernet
then the pe-id , stack-
unit unit number , and port-id . The pe-id range is 0–255;
the stack unit number range is 0–7; and the port—ID range
is 0 –47.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
Dynamic Host Configuration Protocol (DHCP) 836