Dell C9000 series, Справочное руководство

Страница: 489 / 2286

Defaults Disabled
Command Modes ROUTER BGP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage Information This command enables soft-reconfiguration for the BGP neighbor specified. BGP stores
all the updates the neighbor receives but does not reset the peer-session.
CAUTION: Inbound update storage is a memory-intensive operation. The entire
BGP update database from the neighbor is stored in memory regardless of the
inbound policy results applied on the neighbor.
NOTE: This command is supported in BGP Router Configuration mode for IPv4
Unicast address only.
Related
Commands show ip bgp neighbors — displays routes received by a neighbor.
neighbor subnet
Enable passive peering so that the members of the peer group are dynamic.
C9000 Series
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the
no neighbor peer-group-name subnet
subnet-number mask
command.
Border Gateway Protocol 489