Dell C9000 series, Справочное руководство

Страница: 2213 / 2286

primary-priority
Assign the priority for master election among VLT peers.
C9000 Series
Syntax
[no] primary-priority
Parameters
value To configure the primary role of a VLT peer in a VLT domain,
enter a lower value than the priority value of the remote peer.
The range is from 1 to 65535.
Default 32768
Command Modes VLT DOMAIN
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information After you configure a VLT domain on each peer switch and connect (cable) the two
VLT peers on each side of the VLT interconnect, the system elects a primary and
secondary VLT peer device. To configure the primary and secondary roles before the
election process, use the
primary-priority
command. Enter a lower value on the
primary peer and a higher value on the secondary peer.
If the primary peer fails, the secondary peer (with the higher priority) takes the primary
role. If the primary peer (with the lower priority) later comes back online, it is assigned
the secondary role (there is no preemption).
Virtual Link Trunking (VLT) 2213