Dell C9000 series, Справочное руководство

Страница: 1466 / 2286

track interface ip routing
Configure object tracking on the routing status of an IPv4 Layer 3 interface.
C9000 Series
Syntax
track object-id interface interface ip routing
To return to the default setting, use the
no track object-id
command.
Parameters
object-id Enter the ID number of the tracked object. The range is from 1
to 500.
interface Enter one of the following values:
• For a 1-Gigabit Ethernet interface, enter
gigabitethernet
and the slot-number/ port-number.
• For a Loopback interface, enter the keyword
loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords
port-
channel
then a number.
• For a 10-Gigabit Ethernet interface, enter
tengigabitethernet
and the slot-number/ port-
number.
• For a VLAN interface, enter the keyword
vlan
then a
number from 1 to 4094.
Defaults none
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information Use this command to create an object that tracks the routing state of an IPv4 Layer 3
interface:
Object Tracking 1466