To remove the peer from a mesh group, use the
no ip msdp mesh-group {
name
}
{
peer address
}
command.
Parameters
name
Enter a string of up to 16 characters long for as the mesh group
name.
peer address
Enter the peer address in a dotted decimal format (A.B.C.D.).
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.9(0.0)
Introduced on the C9010.
9.5(0.1)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
6.2.1.1
Introduced
Usage Information An MSDP mesh group is a mechanism for reducing SA flooding, typically in an intra-
domain setting. When some subset of a domain’s MSDP speakers are fully meshed, they
can be configured into a mesh-group. If member X of a mesh-group receives a SA
message from an MSDP peer that is also a member of the mesh-group, member X
accepts the SA message and forwards it to all of its peers that are not part of the mesh-
group. However, member X cannot forward the SA message to other members of the
mesh-group.
ip msdp originator-id
Configure the MSDP Originator ID.
C9000 Series
Syntax
ip msdp originator-id {
interface
}
Multicast Source Discovery Protocol (MSDP)
1409
Содержание C9000 series
