Dell C9000 series, Справочное руководство

Страница: 1219 / 2286

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information This command provides egress port information for a given IP flow. This information is
useful in identifying which interface the packet follows in the case of Port-channel and
Equal Cost Multi Paths. Use this command for routed packed only. For switched
packets, use the
show port-channel-flow
command.
The
show ip flow
command does not compute the egress port information when
load-balance mac hashing
is also configured due to insufficient information (the
egress MAC is not available).
S-Series produces the following error message:
%Error: Unable to read IP
route table
.
Example
Dell#show ip flow interface Te 1/8 189.1.1.1 63.0.0.1 protocol
tcp source-port 7898 destination-port 8
flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976
Ingress interface:Te 1/20
Egress interface:Te 1/14 to 1.7.1.2[CAM hit 103710] unfragmented
packet
Te 1/10 to 1.2.1.2[CAM hit 103710] fragmented
packet
show ip interface
View IP-related information on all interfaces.
C9000 Series
Syntax
show ip interface [ interface | brief] [linecard slot-id ]
[configured]
IPv4 Routing 1219