Dell Aurora R6, Руководство по обслуживанию

Страница: 86 / 164

Replacing the processor fan and
heat-sink assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer . After working inside your
computer, follow the instructions in After working inside your
computer . For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance .
Procedure
NOTE: The original thermal grease can be reused if the original
processor and heat-sink assembly are reinstalled together.
CAUTION: If either the processor or the heat-sink assembly is
replaced, use the thermal grease provided in the kit to ensure that
thermal conductivity is achieved.
1 Place the processor fan and heat-sink assembly on the processor.
2 Align the captive screws on the processor fan heat-sink assembly with the
screw holes on the system board.
3 In a non-adjacent sequence, tighten the captive screws that secure the
processor fan and heat-sink assembly to the system board.
4 Connect the processor-fan cable to the system board.
Post-requisites
1 Follow the procedure from step 10 to step 11 in " Replacing the power-supply
unit ".
2 Replace the left-side cover .
86