Dell 7CX5T, Инструкция по установке и обслуживанию

Страница: 101 / 165

Figure 58. Installing a NVMe drive bay or flex bay
Next steps
1. Install the backplane to the NVMe drive bay or flex bay .
2. Connect the slim optical drive and the back plane cables.
3. Follow the procedure listed in
After working inside your system on page 66.
Optical drives and tape drives
Optical drives and tape drives specifications
Your system supports one of the following configurations:
Table 35. System configurations
System Configurations
Eight 3.5 inch drives or sixteen 2.5 inch drives Up to two SATA slim optical drives and one SAS tape drive
Sixteen 2.5 inch drives and eight NVMe drives One SATA slim optical drive
Systems with up to eighteen 3.5 inch drives One SATA slim optical drive or one SAS tape drive
Systems with up to thirty-two 2.5 inch drives One SATA slim optical drive
Removing the optical or tape drive blank
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 65.
2. Follow the procedure listed in Before working inside your system on page 66.
3. If installed, remove the front bezel .
Installing and removing system components 101