About this task
The following image indicates the location of the heat-sink and provides a visual representation of the installation procedure.
Steps
1. Align the heat-sink screw holes with the system board and place it on the system chassis.
2. Replace the four (M2x5) screws (in sequential order, 1->2->3->4) to secure the heat-sink to the system board.
Next steps
1. Install the
.
2. Install the
.
3. Install the
4. Install the
.
5. Install the
.
6. Install the
primary M.2 2280 solid state drive
primary M.2 2230 solid state drive
.
7. Install the
.
after working inside your computer
.
Rear I/O board
Removing the rear I/O board
Prerequisites
before working inside your computer
.
2. Remove the
.
3. Remove the
primary M.2 2280 solid state drive
primary M.2 2230 solid state drive
.
4. Remove the
.
Removing and installing components
61
Содержание 7330
