Getting started
This chapter gives you step-by-step instructions for setting up the USB connected machine and software.
This chapter includes:
Setting up the hardware
Supplied software
System requirements
Installing USB connected machine’s driver
Sharing your machine locally
Setting up the hardware
This section shows the steps to set up the hardware, as explained in the
Quick Install Guide
. Make sure you read the
Quick Install Guide
first and follow the steps below:
1. Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow extra space to open covers and trays.
The area should be well ventilated and away from direct sunlight or sources of heat, cold, and humidity. Do not
set the machine close to the edge of your desk or table.
Printing is suitable for altitudes under 1,000 m (3,281 ft.). Refer to the altitude setting to optimize your printing
(See
Altitude adjustment
).
Place the machine on a flat, stable surface so that there is no incline greater than 2 mm (0.08 inch). Otherwise,
printing quality may be affected.
2. Unpack the machine and check all the enclosed items.
3. Remove all tape.
4. Install the toner cartridge.
5. Load paper (See
Loading paper in the tray
).
6. Make sure that all cables are connected to the machine.
7. Turn the machine on.
