Figure 80. Installing the system battery
Next steps
1. Install the LOM riser card.
2. If applicable, connect the cables to the expansion card(s).
3. Follow the procedure listed in the
After you work inside your system
.
4. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup
Time
and
Date
fields.
c.
Exit
the System Setup.
d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
f. Enter the System Setup and if the time and date are still incorrect, see
Optional internal USB memory key
NOTE:
To locate the internal USB port on the system board, see the
Replace the optional internal USB memory key
Prerequisites
•
Follow the safety guidelines listed in the
•
Follow the procedure listed in the
Before you work inside your system
.
•
About this task
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB
memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
Steps
1. Locate the USB port or USB memory key on the system board.
Installing and removing system components
107
