Figure 47. Installing an expansion card into the expansion riser 2A
Next steps
1
After installing a card into the riser 1, close the PCIe card holder latch. If applicable, close the PCIe guide after installing the expansion
card.
2
Follow the procedures in
After working inside your system
3
Install any device drivers required for the card as described in the documentation for the card.
Network daughter card
The network daughter card (NDC) is a small, removable mezzanine card, which provides the flexibility of selecting different network
connectivity options.
Removing the network daughter card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedures in
Before working inside your system
3
Remove the
, depending on the configuration of your system.
Steps
1
Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
2
Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
3
Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
Installing and removing system components
89
