Installing the front bezel
To install the front bezel:
Prerequisite
Follow the safety guidelines listed in
Steps
1
Locate and remove the bezel key.
2
Align and insert the right end of the bezel onto the system.
3
Press the bezel until the button clicks in place and fit the left end of the bezel onto the system.
4
Lock the bezel using the key.
NOTE:
The images shown here are for representation only and the actual configuration of your system may vary.
Figure 18. Installing the front bezel
System cover
The system cover provides security for the entire system and also helps in maintaining proper air flow inside the system.
Removing the system cover
Prerequisites
1
Follow the safety guidelines listed in
2
Turn off the system, including any attached peripherals.
3
Disconnect the system from the electrical outlet and disconnect the peripherals.
Steps
1
Using a 1/4 inch flat head or a Phillips #2 screwdriver, rotate the latch release lock counter clockwise to the unlocked position.
2
Lift the latch till the system cover slides back and the tabs on the system cover disengage from the guide slots on the system.
3
Hold the cover on both sides, and lift the cover away from the system.
NOTE:
The images shown here are for representation only and the actual configuration of your system may vary.
58
Installing and removing system components
