Dell EMC Storage NX3230, Руководство пользователя

Страница: 82 / 138

警示
:
許多維修僅可由獲得認可的維修技術人員來完成。 您 只能依照 產 品說明文件中的授權說明或在線上或電話服務和支援團隊
的指導下，執行故障排除和簡單的維修。由未經
Dell
授權的維修造成的損壞不在保固範圍之內。請閱讀並遵循隨 產 品寄送的安
全指示。
步驟
1. Align the end of the integrated storage-controller card opposite the connector with the integrated storage-controller card holder.
2. Lower the connector side of the integrated storage-controller card into the integrated storage-controller card connector on the
system board.
Ensure that the tabs on the system board align with the screw holes on the integrated storage-controller card.
3. Align the screws on the integrated storage-controller card cable with the screw holes on the connector.
4. Tighten the screws to secure the integrated storage-controller card cable with the integrated storage-controller card connector on
the system board.
後續步驟
1. Replace the expansion-card riser 1.
2. Replace the cooling shroud.
3. Follow the procedure listed in the After working inside your system section.
相關工作
Before working inside your system
After working inside your system
相關參考
安全說明
Network daughter card
The Network daughter card (NDC) is a small, removable mezzanine card. The NDC provides you with the flexibility of choosing different
network connectivity options, for example—4 x 1GbE, 2 x 10GbE and 2 x Converged Network Adapter.
Removing the network daughter card
事前準備作業
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the expansion card riser 2.
4. Keep the Phillips #1 screwdriver ready.
警示
:
許多維修僅可由獲得認可的維修技術人員來完成。 您 只能依照 產 品說明文件中的授權說明或在線上或電話服務和支援團隊
的指導下，執行故障排除和簡單的維修。由未經
Dell
授權的維修造成的損壞不在保固範圍之內。請閱讀並遵循隨 產 品寄送的安
全指示。
步驟
1. Loosen the captive screws that secure the network daughter card (NDC) to the system board.
2. Hold the NDC by the edges on either side of the touch point, and lift the card to disengage it from the connector on the system board.
3. Slide the NDC away from the back of the system until the Ethernet connectors are clear of the slot in the back panel.
4. Lift the NDC out of the chassis.
82 Installing and removing system components