Dell EMC PowerProtect DD9900, Руководство по установке

Страница: 91 / 96

Table 32 Library page settings (continued)
Item Description
l
TS3500
l
I2000
l
I6000
l
DDVTL
Starting Barcode Enter the desired barcode for the first tape, in the format
A990000LA.
Tape Capacity (Optional) Enter the tape capacity. If not specified, the capacity is
derived from the last character of the barcode.
VTL Protocol Access Group page
The Access Group page enables you to configure DD VTL protocol settings for an access group.
To configure these settings outside of the configuration wizard, select PROTOCOLS
>
VTL
>
Access Groups
>
Groups
>
More Tasks
>
Group
>
Create.
Table 33 Access Group page settings
Item Description
Group Name Enter a unique name of from 1 - 128 characters. Duplicate access groups
are not supported.
Initiators Select one or more initiators. Optionally, replace the initiator name by
entering a new one. An initiator is a backup client that connects to a
system to read and write data using the Fibre Channel (FC) protocol. A
specific initiator can support DD Boost over FC or DD VTL, but not both.
Devices The devices (drives and changer) to be used are listed. These are
available on all endpoints. An endpoint is the logical target on the
protection system to which the initiator connects.
Use iDRAC to power the system on and off remotely
Procedure
1. In a web browser, type the iDRAC IP address specified during iDRAC configuration.
2. Login with the user name root. The default password is the system serial number on the
PSNT.
3. Select Dashboard.
4. Click Graceful Shutdown to initiate the same behavior as pressing the power button, or
select the drop-down arrow to select on the of the following options:
l
Power Off System
l
Reset System (warm boot)
l
Power Cycle System (cold boot)
Configure System for Use
Dell EMC PowerProtect DD9900 System Installation Guide 91