Figure 45. Installing the PSU
Next steps
1
Connect all the power cables from the PSU to the system board connectors.
2
Follow the procedure listed in
After working inside your system
.
System battery
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. See the
safety instructions that came with your system for more information.
1
Follow the safety guidelines listed in the
.
2
Follow the procedure listed in the
Before working inside your system
3
Locate the battery socket. For more information, see the
System board jumpers and connectors
section.
Steps
1
To remove the battery:
a Push the battery holder clip.
NOTE:
Ensure that you do not push the battery holder clip more than 3.2 millimeters, It may damage the battery
holder.
b Lift the battery away from the system.
74
Installing and removing system components
